0 PATTERN GENERATOR PG-Y1 USER MANUAL V.2009PGY101.00 Copyright and Trademarks: All rights reserved by C&C TECHNIC TA
9 3.2 Power and Battery The device is suited to the DC 12V 1.25A power adapter and 4 inside Re-chargeable
10 3.3 MENU Configurations ) The figures in this chapter are for P11 720x480i@29 mode reference After you
11 “▲”: Switch the Pattern mode with up page. (refer to Appendix B: Pattern chart) “▼”: Switch the Pattern mode with down page. (refer to Ap
12 3.3.3 Info configuration Press the Info indicated key, the Info configuration screen will be showed as below: the Info configuration screen inclu
13 Press the “︾” to enter the Hky page 2 configuration screen as below: “O”: Represent for “Enable”. “X”: Represent for “Disable”. “Out”
14 Chapter 4 Troubleshooting 1. If there is no image when using the PG-Y1, please ensure the following mat
15 Appendix A YPbPr Output Signal Specification Chart: NO Resolution Ver Freq (Hz) Pixel Freq (MHz) Sync T
16 Appendix B Pattern chart: 1. FLAT 2. Blinking 3. GRADUALLY 4. GRID_4x3 5. GRID_16x12 6. COLOR_
17 29. BLOCK_1 30. BLOCK_4x3 31. BLOCK_16x12 32. HLINE_1 33. HLINE_2 34. HLINE_3
1 Chapter 1 Introduction ...2 1.1 Package Contents...2 1.2 Resol
2 Chapter 1 Introduction PG-Y1 is a test pattern generator with RCA (YPbPr) connectors designed to be a us
3 1.2 Resolution Use for test and calibrating HDTV equipments. Use for test and calibrating DTV monitor. Use for Video product lines. 1.
4 1.5 Front Panel 1. Video Output Port (Y, Pb, Pr): Connect to the attached Video cable. (refer to 1.6.1 RCA Connector chapter) 2. LCD Module: 16*2
5 1.6 Side Panel 1.6.1 RCA connectors Use for RCA cable connections. These connectors are labeled Y, Pb and Pr. These are HDTV-Component video con
6 Chapter 2 Connection 2.1 Preparation Caution Please power off the TV monitor and PG-Y1 before you begin the connection 2.1.1 Plugs PG-Y1 supports
7 2.2 Connect PG-Y1 to Monitor Connect the attached DC adapter cable from PG-Y1 to the power source (outlet). Connect the RCA cable from PG-Y1
8 Chapter 3 Operation )1. After pressing the power On/Off key for 2~3 seconds to sound a long “beep”. 2. Only for the valid key of PG-Y1 will sound a
Comments to this Manuals